- Jukebox-Teile
- Jukeboxen
- Röhren
- Handbücher
- Allgemeine Teile
- Lautsprecher
- Transformer
- Beleuchtung
- Leuchtreklamen
- Merchandise
- Röhrenverstärker
- Nadeln & Tonabnehmer
- Kondensatoren
- Widerstände
- Halbgeleiter
- Werkzeuge & Wartung
- Bausätze
- Gitarrenverstärker
- HiFi
- Vinylhüllen & Pflege
- solange der Vorrat reicht
- Neu im program
- Vinylplatten
Elekit PS-3250 RIAA pre amplifier
zurück zur Kategorie
Beschreibung
This is an RIAA turntable preamplifier to convert a turntableʼs phono-level output to an RIAA-equalized line-level signal, supporting both MM and MC cartridges by changing a jumper located on the PCB.
For OpAmp, a low-noise NJM2068DD is adopted.
In addition, for the electronic parts, ±1 % tolerance metal oxide resistors and ± 2％ tolerance film capacitors are adopted to realize small RIAA deviation and low noise.
For the equalizer circuit, CR type is adopted and there is no concern for the deviation of equalizing characteristics even when OpAmp is exchanged.
A positve and negative voltage generating circuit is on-board for the power unit, and high quality sound and wide dynamic range are secured by supplying ±15 V for OpAmp.
POP noise suppressor upon power ON/OFF is on-board.
In an equalizer amp, the noise level, especially the hum noise, depends largely on the IN/OUT wiring and the grounding location. Therefore, for this kit, IN/OUT jack and grounding bracket to fix those parts to the PCB are included.
TECHNICAL SPECIFICATION
| CARTRIDGES | MM (approx. 47 kΩ) MC (approx. 100 Ω or 30 Ω) |
| CIRCUIT | CR equalizer (RIAA) OPamp dual amplification |
| RIAA DEVIATION | Within ±0,5 dB (20 Hz - 20 kHz) |
| GAIN (@ 1 kHz) | 27 dB (MM, LOW-G) 32 dB (MM, MID-G) 36 dB (MM, HIGH-G) 56 dB (MC, LOW-G) 62 dB (MC, MID-G) 65 dB (MC, HIGH-G) |
| NON CLIP MAX. OUTPUT (@ 1 kHz) | 9 V RMS |
| POWER VOLTAGE | DC 5 V - 12 V |
| POWER CONSUMPTION (OPamp: NJM2068DD) |
100 mA (5 V) 30 mA (12 V) |
| PCB SIZE | 100 x 80 mm |
De PS-3250 vereist een externe voeding (gestabiliseerd) van 5 V - 12 V.
